User`s manual

User’s Manual 339
seconds Interval between time requests. (Range: 16 - 16384 seconds)
Default
16 seconds
Command Mode
Global Configuration
Usage Guidelines
This command is only applicable when the switch is set to SNTP client Command Mode.
Example
The following is sample output from the sntp poll command.
Console(config)#sntp poll 60
Console#
Related Commands
sntp client
16.210 sntp server
This command sets the IP address of the servers to which SNTP time requests are issued. Use the this
command with no arguments to clear all time servers from the current list.
Syntax Description
sntp server [ip1 [ip2 [ip3]]]
ip IP address of an time server (NTP or SNTP). (Range: 1-3 addresses)
Default
None
Command Mode
Global Configuration
Usage Guidelines
This command specifies time servers from which the switch will poll for time updates when set to SNTP
client mode. The client will poll the time servers in the order specified until a response is received. It issues
time synchronization requests based on the interval set via the sntp poll command.
Example
The following is sample output from the sntp server command.