User`s manual

336 Asanté IntraCore 36000 Series
version Specifies whether to send notifications as SNMP v1 or v2c traps.
Default
Host Address: None
SNMP Version: 1
Command Mode
Global Configuration
Usage Guidelines
If you do not enter an snmp-server host command, no notifications are sent. In order to configure the switch
to send SNMP notifications, you must enter at least one snmp-server host command. In order to enable
multiple hosts, you must issue a separate snmp-server host command for each host.
The snmp-server host command is used in conjunction with the snmp-server enable traps command. Use
the snmp-server enable traps command to specify which SNMP notifications are sent globally. For a host to
receive notifications, at least one snmp-server enable traps command and the snmp-server host command
for that host must be enabled.
Some notification types cannot be controlled with the snmp-server enable traps command. For example,
some notification types are always enabled.
The switch can send SNMP version 1 or version 2c notifications to a host IP address, depending on the
SNMP version that the management station supports. If the snmp-server host command does not specify
the SNMP version, the default is to send SNMP version 1 notifications.
Example
The following is sample output from the snmp-server host command.
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
Related Commands
snmp-server enable traps
16.206 snmp-server location
This command sets the system location string. Use the no form to remove the location string.
Syntax Description
snmp-server location text
no snmp-server location
text String that describes the system location. (Maximum length: 255 characters)