User`s manual

26 Asanté IntraCore 36000 Series
2.4.1 Manual Configuration
You can manually assign an IP address to the switch. You may also need to specify a default gateway that
resides between this device and management stations that exist on another network segment. Valid IP
addresses consist of four decimal numbers, 0 to 255, separated by periods.
Before you can assign an IP address to the switch, you must obtain the following information from your
network administrator:
• IP address for the switch
• Default gateway for the network
• Network mask for this network
To assign an IP address to the switch, complete the following steps:
1. From the Privileged Exec level global configuration mode prompt, type “interface vlan 1” to access the
interface-configuration mode and press Enter.
2. Type “ip address ip-address netmask,” where “ip-address” is the switch IP address and “netmask” is the
network mask for the network and press Enter.
3. Type “exit” to return to the global configuration mode prompt and press Enter.
4. To set the IP address of the default gateway for the network to which the switch belongs, type “ip
default-gateway gateway,” where “gateway” is the IP address of the default gateway and press Enter.
Web
Click System – IP Configuration. Select the VLAN through which the management station is attached, set
the IP Address Mode to “Static,” enter the IP address, subnet mask and gateway, then click Apply.
CLI
Specify the management interface, IP address and default gateway.
Console#config
Console(config)#interface vlan 1
Console(config-if)#ip address 10.1.0.254 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 192.168.1.254
Console(config)#