User`s manual

252 Asanté IntraCore 36000 Series
A packet matching a rule within the specified ACL then maps to one of the output queues as shown below.
Priority 0 1 2 3 4 5 6 7
Queue 1 2 0 3 4 5 6 7
Example
Console(config)#int eth 1/5
Console(config-if)#map access-list mac M5 cos 0
Console(config-if)#
Related Commands
queue cos-map
show map access-list mac
16.102 map ip dscp (Global Configuration)
This command enables IP DSCP mapping (For example, Differentiated Services Code Point mapping). Use
the no form to disable IP DSCP mapping.
Syntax Description
[no] map ip dscp
Default
Disabled
Command Mode
Global Configuration
Usage Guidelines
The precedence for priority mapping is IP Port, IP Precedence or IP DSCP, and default switchport priority.
IP Precedence and IP DSCP cannot both be enabled. Enabling one of these priority types will automatically
disable the other type.
Example
The following example shows how to enable IP DSCP mapping globally:
Console(config)#map ip dscp
Console(config)#
16.103 map ip dscp (Interface Configuration)
This command sets IP DSCP priority (For example, Differentiated Services Code Point priority). Use the no
form to restore the default table.