User`s manual

222 Asanté IntraCore 36000 Series
This command defines the time after a query, during which a response is expected from a multicast client. If
a querier has sent a number of queries defined by the ip igmp snooping query-count, but a client has not
responded, a countdown timer is started using an initial value set by this command. If the countdown
finishes, and the client still has not responded, then that client is considered to have left the multicast group.
Example
The following shows how to configure the maximum response time to 20 seconds:
Console(config)#ip igmp snooping query-max-response-time 20
Console(config)#
Related Commands
ip igmp snooping version
16.65 ip igmp snooping router-port-expire-time
This command configures the query timeout. Use the no form to restore the default.
Syntax Description
ip igmp snooping router-port-expire-time seconds
no ip igmp snooping router-port-expire-time
seconds The time the switch waits before it considers the router port (for example, the
interface which had been receiving query packets) to have expired. (Range:
300-500)
Default
300 seconds
Command Mode
Global Configuration
Usage Guidelines
The switch must use IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Related Commands
ip igmp snooping version