User`s manual

210 Asanté IntraCore 36000 Series
Console(config-if)#
Related Commands
show ip access-list
16.49 ip address
This command sets the IP address for the currently selected VLAN interface. Use the no form to restore the
default IP address.
Syntax Description
ip address {ip-address netmask | bootp | dhcp}
no ip address
ip-address IP address
netmask Network mask for the associated IP subnet. This mask identifies the host
address bits used for routing to specific subnets.
Bootp Obtains IP address from BOOTP.
dhcp Obtains IP address from DHCP.
Default
DHCP
Command Mode
Interface Configuration (VLAN)
Usage Guidelines
You must assign an IP address to this device to gain management access over the network. You can
manually configure a specific IP address, or direct the device to obtain an address from a BOOTP or DHCP
server. Valid IP addresses consist of four numbers, 0 to 255, separated by periods. Nothing outside this
format will be accepted by the configuration program.
If you select the bootp or dhcp option, IP is enabled but will not function until a BOOTP or DHCP reply has
been received. Requests will be broadcast periodically by this device in an effort to learn its IP address.
(BOOTP and DHCP values can include the IP address, default gateway, and subnet mask).
You can start broadcasting BOOTP or DHCP requests by entering an ip dhcp restart command, or by
rebooting the switch.
Note: Before you change the IP address, you must first clear the current address with the no form of this
command.
Example
In the following example, the device is assigned an address in VLAN 1.