User`s manual

User’s Manual 175
15.18 IP Interface Commands
There are no IP addresses assigned to this switch by default. You must manually configure a new address
to manage the switch over your network. You may also need to a establish a default gateway between this
device and management stations or other devices that exist on another network segment.
The following table lists the basic IP configuration commands.
Command Function Mode
ip address Sets the IP address for the current interface IC
ip default-gateway Defines the default gateway through which this switch can reach
other subnetworks
GC
show ip interface Displays the IP settings for this device PE
show ip redirects Displays the default gateway configured for this device PE
ping Sends ICMP echo request packets to another node on the network NE, PE