User`s manual

168 Asanté IntraCore 36000 Series
• If the port channel admin key is set, then the port admin key must be set to the same value for a port to
be allowed to join a channel group.
• If a link goes down, LACP port priority is used to select the backup link.
15.12 Address Table Commands
These commands are used to configure the address table for filtering specified addresses, displaying
current entries, clearing the table, or setting the aging time.
Command Function Mode
mac-address-table static Maps a static address to a port in a VLAN GC
clear mac-address-table
dynamic
Removes any learned entries from the forwarding database PE
show mac-address-table Displays entries in the bridge-forwarding database PE
mac-address-table aging-
time
Sets the aging time of the address table GC
show mac-address-table
aging-time
Shows the aging time for the address table PE
15.13 Spanning Tree Commands
This section includes commands that configure the Spanning Tree Algorithm (STA) globally for the switch,
and commands that configure STA for the selected interface.
Command Function Mode
spanning-tree Enables the spanning tree protocol GC
spanning-tree mode Configures STP, RSTP or MSTP mode GC
spanning-tree forward-
time
Configures the spanning tree bridge forward time GC
spanning-tree hello-time Configures the spanning tree bridge hello time GC
spanning-tree max-age Configures the spanning tree bridge maximum age GC
spanning-tree priority Configures the spanning tree bridge priority GC
spanning-tree path-cost
method
Configures the path cost method for RSTP/MSTP GC
spanning-tree
transmission-limit
Configures the transmission limit for RSTP/MSTP GC
spanning-tree mst-
configuration
Changes to MSTP configuration mode GC