User`s manual

150 Asanté IntraCore 36000 Series
access-list mac mask-precedence Console(config-mac-mask-acl)
For example, you can use the following commands to enter interface configuration mode, and then return to
Privileged Exec mode
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#
14.3 Command Groups
The system commands can be broken down into the functional groups shown below.
Command Group Description
Line Sets communication parameters for the serial port and Telnet, including baud rate and
console time-out
General Basic commands for entering privileged access mode, restarting the system, or quitting
the CLI
System Management Controls system logs, system passwords, user name, browser management options, and
a variety of other system information
Flash/File Manages code image or switch configuration files
Authentication Configures logon access using local or remote authentication; also configures port
security and IEEE 802.1x port access control
Access Control List Provides filtering for IP frames (based on address, protocol, TCP/UDP port number or
TCP control code) or non-IP frames (based on MAC address or Ethernet type)
SNMP Activates authentication failure traps; configures community access strings, and trap
managers; also configures IP address filtering
DHCP Configures DHCP client
DNS Configures DNS services.
Interface Configures the connection parameters for all Ethernet ports, aggregated links, and VLANs
Mirror Port Mirrors data to another port for analysis without affecting the data passing through or the
performance of the monitored port
Rate Limiting Controls the maximum rate for traffic transmitted or received on a port
Link Aggregation Statically groups multiple ports into a single logical trunk; configures Link Aggregation
Control Protocol for port trunks
Address Table Configures the address table for filtering specified addresses, displays current entries,