User`s manual

User’s Manual 131
Command Attributes
IP Precedence Priority Table – Shows the IP Precedence to CoS map.
Class of Service Value – Maps a CoS value to the selected IP Precedence value. Note that “0” represents
low priority and “7” represent high priority.
Configuring Switch Using the Web or CLI
Web
Click Priority – IP Precedence Priority. Select an entry from the IP Precedence Priority Table, enter a
value in the Class of Service Value field, and then click Apply.
CLI
The following example globally enables IP Precedence service on the switch, maps IP Precedence value 1
to CoS value 0 (on port 1), and then displays the IP Precedence settings.
Console(config)#map ip precedence
Console(config)#interface ethernet 1/1
Console(config-if)#map ip precedence 1 cos 0
Console(config-if)#end
Console#show map ip precedence ethernet 1/1
Precedence mapping status: disabled
Port Precedence COS
--------- ---------- ---
Eth 1/ 1 0 0
Eth 1/ 1 1 0
Eth 1/ 1 2 2
Eth 1/ 1 3 3
Eth 1/ 1 4 4
Eth 1/ 1 5 5
Eth 1/ 1 6 6
Eth 1/ 1 7 7
Console#
Mapping specific values for IP Precedence is implemented as an interface configuration command, and any
changes apply to the all interfaces on the switch.