Setup guide

Setup Guide

Note: This switch has no uplink port. All 10/100/1000 ports on this

switch are auto-sensing MDI/MDI-X. This advanced feature means

that the 10/100/1000 ports will automatically determine whether the

device at the other end of the link is a hub, switch, or workstation,

and adjust its signals accordingly.

Although 10BaseT requires only pins 1, 2, 3, and 6, Asanté strongly

recommends cables with all 8 pins wired as shown in the following

table. Use Category 5 (or better) Unshielded Twisted Pair (UTP)

cables.

1000BaseT DOES require that all four pairs (8 wires) be connected

correctly. The following table shows the correct pairing of all eight

wires.

WH/BR

WH/BL

WH/GR

WH/OR

Pin Number Pair Number & Wire Colors

1 2 White/Orange

2 2 Orange/White

3 3 White/ Green

4 1 Blue/White

5 1 White/Blue

6 3 Green/White

7 4 White/Brown

8 4 Brown/White