Setup guide

Setup Guide

could void the product’s warranty

• Examine the work area for potential hazards (such as wet

floors or ungrounded cables) and eliminate them before install-

ing the switch

For more safety information, please refer to the User’s Manual.

2.2 Recommended Installation Tools

The following tools and equipment (not in-

cluded) are needed to install the switch:

• Flat head screwdriver

• Phillips head screwdriver

• Antistatic mat or foam

2.3 Power Requirements

The electrical outlet should be located near the switch and be easily

accessible. It must also be properly grounded.

Make sure the power source adheres to the following guidelines:

• Power: Auto-switching 110/240 VAC

• Frequency range: 50/60 Hz

• Maximum input AC Current: 1.0A at 115 VAC full load

2.4 Environmental Requirements

The switch must be installed in a clean, dry, dust-free area

with adequate air circulation to maintain the following environ-

mental limits:

• Operating Temperature: 0° to 40° C (32° to 104° F)

• Relative Humidity: 10% to 90% non-condensing