Installation guide

Page 3-6
Configuration
The Port Parameter Menu appears as shown below:
This menu allows you to control whether ports are enabled
or disabled.
5
To change the status of a port from Enabled to Disabled,
select c.
∆ Note: To change it back to enabled, select c again.
6
To apply the current settings, press s.
The system asks if you are sure you want to set these param-
eters.
7
Press y to confirm.
8
To enter parameters for the next port, select n.
9
Follow steps 4 through 6 for each port that you want to
change.
To go back to a previous port, select p.
10
When finished entering all the port parameters, select q.