Installation guide

Page 3-4
Configuration
The TCP/IP Parameter Menu appears as shown below.
5
The Hub IP Address is the assigned Internet protocol
address for the hub. It is a 32-bit number that uniquely
identifies the network and the host on that network.
Select i to change the default. Type your own unique
32-bit Address at the address prompt. Press ENTER.
6
The Hub Subnet Mask is the Internet Mask that defines the
host’s sub network. This is a 32-bit field. The Network Man-
ager specifies which fields (i.e. which bytes) define a partic-
ular sub network. Select m to change the default. Type in
your own unique 32-bit Mask number. Press ENTER.
7
The Hub Default Router specifies the gateway host for the
hub. The address is 32-bits long. Select r to change the
default. Type in your own unique 32-bit IP Address. Press
ENTER.
8
When you are finished entering this information, select q
to return to the Configuration Menu.
9
To review your configuration information, select g while in
the Main Menu.