Installation guide

Page 3-2
Configuration
5
Adjust your particular Terminal Emulator Software accord-
ing to the data in the following table:
6
When finished entering this data, power on the hub.
If you are connected properly, the terminal will display the
hub’s boot prompts as shown below.
When the boot prompts are finished scrolling, the Main
Menu appears as shown below.
∆ Note: If you run the terminal emulator after turning on
the hub, the Main Menu will not appear. To refresh the
display, press ENTER.
Parameters Value
Speed (baud rate) 9600
Data Bits 8
Parity none
Stop Bits 1
Flow Control XON/XOFF (Software)
RTS/CTS (Hardware)
Terminal Emulation VT-100 or ANSI