Installation guide

3
Configuration
After installing the AsantéHub 1016-IQ, you are ready to configure the hub
to work with the Simple Network Management Protocol (SNMP).
Requirements
To configure the IP address, you must have the following resources:
❏ 286 PC or above
❏ AsantéHub 1016-IQ
❏ Terminal program for MS-Windows or other Terminal
Emulator (e.g., XTALK, Procomm)
Out-of-Band Network Management
Out-of-Band management is used to configure the AsantéHub 1016-IQ
through an RS-232 link. In order to configure the hub, you may use a PC
running Terminal Emulation software (e.g. Windows Terminal Program,
XTALK, etc.), or an asynchronous terminal.
1
Run the appropriate Terminal software.
XTALK is being used in this example.
2
Insert the XTALK Disk into drive A.
3
To run XTALK, go to the XTALK directory by typing the fol-
lowing line of text at the command prompt:
A:\CD\XTALK
4
Execute the XTALK command file by typing the following
line of text at the command prompt:
A:\XTALK>XTALK