Installation guide

Page 2-3
EtherPaC 2000+ Installation Guide
To set the adapter into Jumperless mode:
❏ Remove the jumper on jumper-pair 8 of JP1 (default set-
ting)
❏ Use the SETUP.EXE program to set to Jumperless mode
Jumper mode
When using the adapter in Jumper mode, you can configure the adapter
with jumper settings JP1 and JP2. (See Appendix A for a description of
jumper settings.)
To set the adapter into Jumper mode:
❏ Place the jumper on jumper-pair 8 of JP1
Full Duplex mode
The adapter supports full duplex mode, which transmits and receives data
simultaneously. Full duplex mode is set by using the SETUP.EXE program.
Refer to the README.EXE program for details on using the SETUP.EXE pro-
gram.
Important : If the adapter is set to full duplex mode, the hub
it is connected to should be a switching hub that
supports full duplex mode.
Testing the Adapter
The SETUP.EXE program provides diagnostic software for testing the Ether-
PaC 2000+ adapter. The diagnostic program checks the adapter then reports
the results. It can help you to isolate any problem on the adapter and figure
out whether the problem is caused by the adapter or the cable. The diagnos-
tic program can be used at any time.
Important: Make sure the drivers are not loaded into mem-
ory before running the diagnostic program. If you
are using Windows 95, restart the computer in
the MS-DOS mode to prevent Windows 95 from
loading drivers.
EPaC 205-01A Book Page 3 Wednesday, October 15, 1997 3:40 PM