Installation guide

Page 2-2
Installing the Adapter
Optional AUI Connector
An optional AUI connector is available from Asanté (see back cover). The JP3
connector on the adapter is used to attach a cable to a bracket with the AUI
connection.
To install the AUI connector cable:
1
Hook up the cable to the connector marked JP3: AUI.
Important : Make sure the red line on the cable is aligned
with the pin 1 (lower left) location.
2
Secure the bracket to the computer.
Configuring the Adapter
The EtherPaC 2000+ adapter provides three methods for configuration (set-
ting IRQ and I/O base addresses): Plug-and-Play mode, Jumperless mode, and
Jumper mode.
Plug-and-Play mode (default mode)
When using the adapter in a Plug-and-Play-compliant system, no software or
jumper-setting configuration is needed. The Plug-and-Play system automati-
cally configures the adapter.
To set the adapter into Plug-and-Play mode:
❏ Remove the jumper on jumper-pair 8 of JP1 (default set-
ting)
Jumperless mode
When using the adapter in Jumperless mode in a non-Plug-and-Play-compli-
ant system, you can configure the adapter by software configuration with
the SETUP.EXE program. (Refer to the README.EXE program for details on
using the SETUP program to configure the adapter.)
EPaC 205-01A Book Page 2 Wednesday, October 15, 1997 3:40 PM