Installation guide

Page 2-1
2
Installing the Adapter
Using the EtherPaC 2000+ Ethernet adapter to set up your PC network,
install the adapter in the computer.
Note: You do not need to set any jumpers or switches on the adapter
unless it is necessary to assign specific IRQ and I/O addresses.
1
Turn the power off and remove the computer cover.
2 Align the adapter’s edge connector with an expansion slot.
3
Push the adapter down into the slot until the adapter locks into
place, as illustrated in Figure 2-1.
Figure 2-1 Inserting the adapter in an expansion slot
4
Replace the computer cover.
5
Attach the network cable. The adapter provides two connectors
for connecting to an Ethernet network: RJ-45 or BNC. (An
optional AUI connector is also available.)
6 Power on the computer.
EPaC 205-01A Book Page 1 Wednesday, October 15, 1997 3:40 PM