Installation guide

Page A-1
A
Jumper Configuration
The EtherPaC 2000+ Adapter can be configured by either jumper settings or
software. Please refer to the following illustrations and tables for a detailed
description of the jumper settings.
Important: You only need to set the jumper when the card is
in Jumper mode.
Hardware jumper setting
Figure A-1 EtherPaC 2000+ Adapter
JP1: 8 OPEN : Jumperless/Plug-and-Play mode
CLOSE : Jumper mode
Figure A-2 JP1 and JP2 diagram
JP1 JP3JP2
AUI Port
1
8
JPRI/O
IRQ
JP1
BROM ADDRESS
JP2
EPaC 205-01A Book Page 1 Wednesday, October 15, 1997 3:40 PM