Installation guide

Page 4-2
Remote Boot ROM
4 Gently press the ROM into the socket (see Figure 4-1). Be careful
not to bend the pins.
Figure 4-1 Boot ROM socket on the adapter
5 Install the EtherPaC 2000+ adapter in the PC, then turn on the
PC.
Enable Boot ROM Function
To use the Remote Boot function, you also need to enable the Boot ROM
function in the SETUP.EXE program. Run the setup program from the driver
diskette, select Manual Setup Configuration and enable the Boot ROM
function.
Setting the Boot ROM Address
The Boot ROM address can be setup by running the SETUP.EXE program and
selecting the Boot ROM parameter. If using Jumper mode, you need to
setup the Boot ROM address using jumpers on JP2.
Preparing the Network Server and PC
The procedure for preparing the server and the PC to use a Boot ROM is
dependent upon the Boot ROM product and the network operating system
you are using. Please refer to the user documentation that came with your
Boot ROM for instructions on preparing the network server and PC. Also
see the README.EXE program for detailed instructions on setting up the
network software.
Boot ROM socket
EPaC 205-01A Book Page 2 Wednesday, October 15, 1997 3:40 PM