Installation guide

Page 3-3

EtherPaC 2000+ Installation Guide

Note: The EtherPaC 2000+ adapter is a Plug-and-Play module with

Windows 95; no separate driver installation is needed. After inserting

the adapter into your computer, Windows 95 will automatically detect

and install the Novell NE2000 driver for use with the adapter.

The Windows 95 installation disks or CD is needed to complete

this installation.

1 Install the adapter into an expansion slot.

2 Power on the computer, then start Windows 95.

When Windows 95 starts, a “New Hardware Found” window

appears.

Note: If the “New Hardware Found” window does not

appear, you need to conﬁgure the adapter using the Add

New Hardware wizard in the Windows 95 Control Panel.

3 Select Windows default driver, then click OK.

Note: If you have not installed a network adapter on the

computer before, Windows 95 may prompt you to enter the

computer name and workgroup name.

4 Click Yes to restart the computer.

Microsoft Windows NT Workstation 4.0

This section explains how to install the drivers to use your adapter with

Windows NT Workstation 4.0. The instructions require that you have previ-

ously installed Windows NT 4.0 on your computer without installing a net-

work adapter or driver.

1 Install the adapter into your computer, then power on the com-

puter.

2 Start Windows NT 4.0, then click the Start button.

3 Open the Settings menu and select Control Panel.

EPaC 205-01A Book Page 3 Wednesday, October 15, 1997 3:40 PM