Installation guide

Page 5-4
Remote Boot ROM
1
Insert the Asanté EtherPaC 2000+ Adapter Driver Diskette into
drive A:.
2
From the DOS command line, type the following:
A:SETUP
3
Press Enter.
A screen appears showing the board model.
4
Press Enter to continue.
A screen appears titled Note About Setup.
5
Press any key to continue.
The Setup program searches for the EtherPaC 2000+ adapter.
A screen appears showing three options:
❏
CONFIG BOARD 1
❏ DIAGNOSTIC 1
❏ EXIT
6
Select CONFIG BOARD 1 and press Enter to configure the board.
The NIC Board Setup screen appears.
7
Select MODE and press Enter.
The OPERATING MODE screen appears.
8
Select NE2000 COMPATIBLE and press Enter.
9
Select BOOT ROM and press Enter.