Installation guide

Page 5-2
Remote Boot ROM
Booting Your PC From a Server
You may want to boot up your PC from a remote server on the network. Or
you may have a PC without a boot diskette or a disk drive and need to boot
it up from a remote server.
To boot the PC from a server, you need to:
❏ Install the remote boot ROM on the EtherPaC 2000+
adapter
❏ Install Novell NetWare software on the network
❏ Prepare the PC
❏ Prepare the server
The Boot ROM allows you to load the PC operating system over the net-
work. This chapter provides instructions for the steps required.
Installing the Boot ROM
You install the Boot ROM in the ROM socket of the EtherPaC 2000+ adapter.
1
If the EtherPaC 2000+ is installed in the PC and connected to the
network, turn off the PC, then disconnect and remove the
adapter.
2
Take the Boot ROM out of its protective packaging.
3
Check all pins on the ROM to make sure none are bent.
4
Locate the socket for the Boot ROM on the adapter.