Installation guide

Page 4-2
LED Indicators
Figure 4-1 shows two LED indicators that indicate the presence of station
Link and Activity status for installation verification and diagnostic purposes.
Figure 4-1 LED Indicators
Activity LED
The red Activity LED is located on the left of the rear bracket. It indicates the
activity (transmit and receive data) status of the EtherPaC 2000+ controller
board. The LED should blink when data packets are being transmitted or
received from the cable.
Table 4-1 shows Activity LED status states.
Table 4-1 Status of the Activity LED
State Description
Blinking Data packets being transmitted or received
Off Power off
No data packets being transmitted or received
Link LEDActivity LED