Installation guide

Page 3-17
Microsoft Workgroup Add-On for Windows
Microsoft Workgroup Add-On for
Windows
This section shows you how to install Microsoft Workgroup Add-On for Win-
dows so you can use the EtherPaC 2000+ adapter with it. The instructions
assume that you’ve already installed and configured the EtherPaC 2000+
adapter, that you’ve installed Windows 3.1, that no network driver is
installed, and that you’re using drive A: for the installation diskette.
1
Insert Disk 1 (Setup) from the Windows for Workgroups Add-On
disk set into drive A:.
2
From the DOS command line, type the following:
A:SETUP /I
3
Press Enter.
4
Follow the instructions on the screen for installing the Work-
group for Windows Add-On software.
In the System Information screen, be sure to select descriptions
that match the hardware on your system. Refer to your Microsoft
Workgroup Add-On for Windows User’s Guide for additional
information.
5
When the Network Setup window appears, click the Continue
button.
6
When the installation finishes, click the button for restarting the
computer.