Installation guide

Page 3-10
Installing Drivers
22
Press the down arrow key to highlight Memory I/O Address and
press Enter.
The Memory I/O Address window appears.
23
Using the arrow keys, select none.
24
Press Enter.
You’re taken back to the Settings window.
25
Leave the Optional Node Address field blank.
The driver defaults to the node address of the board.
If you change this address, you must administer local addresses
according to IEEE 802.2 specifications.
26
When you’re finished setting installation parameters, press ESC.
27
Press Enter to start the installation.
You’re prompted to insert the NetWare Client for DOS and
MS-Windows Installation Diskette #1 into drive A:.
28
Eject the Asanté EtherPaC 2000+ Adapter Driver Diskette from
the floppy drive and insert the NetWare Client for DOS and
MS-Windows Installation Diskette #1 diskette.
29
Press Enter to continue.
The installation program copies the appropriate files.
You’re prompted to insert the NetWare Client for DOS and
MS-Windows Installation Diskette #2 into drive A:.