Installation guide

Page 3-8
Installing Drivers
The Settings for the Asanté EtherPaC 2000+ Adapter window
appears.
14
Press Enter to select the base I/O port.
The Base I/O Port window appears.
15
Using the arrow keys, select the base I/O port address you used
when you configured the EtherPaC 2000+ adapter. The following
choices are available:
❏ 300 (default)
❏ 320
❏ 340
❏ 360
❏
240
❏ 280
❏ 2C0
∆ You should avoid base I/O port address 360 if you have a
parallel printer.
16
Press Enter.
You’re taken back to the Settings window.
17
Press the down arrow key to highlight Hardware Interrupt and
press Enter.
The Hardware Interrupt window appears.
18
Using the arrow keys, select the interrupt number you used
when you configured the EtherPaC 2000+ adapter. The following
choices are available:
❏ 2