Installation guide

Page 3-4
Installing Drivers
4
Remove the WSGEN or master workstation diskette from the
floppy drive.
5
Insert the Asanté EtherPaC 2000+ Adapter Driver Diskette into
floppy drive A:.
6
Copy the
net.cfg
and
epc2000.com
files to the NETWARE direc-
tory on your C: drive. To do this, type:
COPY A:\NETWARE\DOSODI\NET.CFG C:\NETWARE
COPY A:\NETWARE\DOSODI\EPC2000.COM C:\NETWARE
7
Check your
CONFIG.SYS
file to make sure that this line appears:
DEVICE=C:\DOS\SETVER.EXE
If you don’t see it there, type it in, then save the file.
∆ The
SETVER.EXE
file must be in the C:\DOS directory.
8
Remove the EtherPaC 2000+ Adapter Driver Diskette from the
floppy drive.
9
Restart your computer.
10
To run NetWare, type the following four commands at the
C:\NETWARE prompt:
LSL
EPC2000
IPXODI
NETX
11
Change to the network drive (usually F:).