Installation guide

Page 3-3
Novell NetWare 3.x
Novell NetWare 3.x
This section shows you how to install Novell NetWare version 3.x so you
can use your adapter with it. The instructions assume that
❏ You’ve already installed and configured the EtherPaC
2000+ adapter
❏ You have not previously installed NetWare software on
the computer
❏ No network driver is installed
❏ You’re using drive A: for the installation diskette
∆ If Novell NetWare software and/or network drivers have
previously been installed on your computer, you should
consult your network administrator and/or the Novell
NetWare documentation before proceeding.
1
Create a directory named NETWARE on your C: drive.
To do this, type the following command at the DOS command
line prompt:
MD C:\NETWARE
2
Insert either the NetWare WSGEN diskette or your master work-
station diskette into drive A:.
3
Copy the following three files to the NETWARE directory on your
C: drive.
❏ LSL.COM
❏ IPXODI.COM
❏ NETX.COM