Installation guide

Page 2-9
Testing the Adapter
11
If you’re using shared memory mode, select MEM. ADDR and
press Enter.
If you select shared memory mode, you must assign a memory-
mapped buffer for your adapter. Make sure that the memory-
mapped buffer address does not overlap with the boot ROM
address.
12
Select the memory address and press Enter.
13
Select SAVE and EXIT, then press Enter.
The Setup program writes and saves the configuration to the
adapter’s EEPROM.
A message appears telling you the configuration is successful.
14
Press any key to continue.
Testing the Adapter
The Setup program provides software for testing the EtherPaC 2000+
adapter.
The diagnostic program checks the adapter, then reports the results.
It can help you to isolate any problem on the adapter and to figure
out whether the problem is caused by the adapter or the cable. You
can use the diagnostic program at any time.
∆ The diagnostic program only supports NE2000 Compati-
ble Mode.
To run the diagnostic program, follow the procedure below. The
instructions assume you’re using drive A: for the driver diskette.