Installation guide

Page 2-8

Installing the EtherPaC 2000+ Adapter

Select an IRQ number and press Enter.

This parameter is used to choose the interrupt line to transfer

data from the network. (The EtherPaC 2000+ cannot work in

shared IRQ mode. You cannot choose an IRQ line that is already

being used by another adapter in your system.)

Select INTERFACE and press Enter.

The following two options appear:

❏

RJ45 (10BASE-T) (default)

❏

BNC/AUI

The EtherPaC 2000+ adapter provides three connectors for users

to attach the computer to the network through different

medium. This option is used for you to select RJ45 to connect to

10BASE-T Ethernet, AUI to connect to 10BASE-5 Thick Ethernet,

or BNC to connect to 10BASE-2 Thin Ethernet.

Select the connector type and press Enter.

Select BOOT ROM and press Enter.

This option is used to disable or set the boot ROM address. It sets

the boot ROM address you want to use in the EtherPaC 2000+

adapter.

If you have an auto boot ROM in your workstation, you must set

the boot ROM memory address. Be sure to choose an address

range that doesn’t overlap with other adapters or memory man-

agers in the workstation. If the address range overlaps with

another adapter’s memory space, one or both of the adapters

will operate improperly, or your workstation may fail to boot.

Select DISABLE or a boot ROM address and press Enter.