Installation guide

Page 2-5
Configuring the Adapter
You use the
Setup
program to configure the adapter. The program is on the
Asanté EtherPaC 2000+ Adapter Driver Diskette.
This section shows you how to start the Setup program from DOS. The
instructions assume you’re using drive A: for the installation diskette.
1
Insert the Asanté EtherPaC 2000+ Adapter Driver Diskette into
drive A:.
2
From the DOS command line, type the following:
A:SETUP
3
Press Enter.
A screen appears showing the board model.
4
Press Enter to continue.
A screen appears titled Note About Setup.
5
Press any key to continue.
The Setup program searches for the EtherPaC 2000+ adapter.
A screen appears showing three options:
❏ CONFIG BOARD 1
❏ DIAGNOSTIC 1
❏ EXIT
6
Select CONFIG BOARD 1.
7
Press Enter to configure the board.
The NIC Board Setup screen appears. It includes:
❏ MODE