Installation guide

Page 2-4
Installing the EtherPaC 2000+ Adapter
2
Attach both ends of the T-connector to the network thin coaxial
cabling.
3
If the adapter is at the end of the network segment, install a 50
ohm terminator to the end of the T-connector that is not con-
nected to the network.
Connecting to the AUI Connector
To use a MAU or other transceiver on the AUI (DB15) port, follow the con-
nection instructions included with the device.
Connecting the Crossover Cable
The EtherPaC 2000+T 2-user pack contains a crossover cable for connecting
two PCs. To use the crossover cable:
1
Plug in the crossover cable’s RJ45 connector into the RJ45
socket of one PC.
2
Plug the network cable’s RJ45 connector into the RJ45 socket of
the crossover cable.
3
Plug the other end of the network cable’s RJ45 connector into
the RJ45 socket of the other PC.
Configuring the Adapter