Installation guide

Page 2-3
Installing the Adapter
4
Replace the computer cover.
5
Attach the network cable. The adapter provides three connec-
tors for you to connect RJ45, AUI, or BNC to your Ethernet net-
work.
6
Turn the computer power on.
7
Run the Setup program to configure the adapter. Make sure that
the I/O address, memory address, and the interrupt line do not
conflict with other add-on cards.
Connecting to the RJ45 Connector
To use 10BASE-T (twisted-pair) cabling:
1
Plug in the network cable’s RJ45 connector into the RJ45 socket.
2
Plug the other end into the 10BASE-T network hub or wall
socket.
Connecting to the BNC Connector
To use 10BASE-2 (thin coaxial) cabling:
1
Attach a T-connector to the BNC connector on the adapter.