Installation guide

Page 2-2
Installing the EtherPaC 2000+ Adapter
Installing the Adapter
You should use the IEEE 802.3 standard to plan your network.
Using the EtherPaC 2000+ jumperless Ethernet adapter to set up your PC
network, install the adapter in the computer.
∆ You do not need to set any jumpers or switches on the
adapter.
1
Turn the power off and remove the computer cover.
2
Align the adapter’s edge connector with an expansion slot.
3
Push the adapter down into the slot until the adapter locks into
place. Figure 2-1 shows an example.
Figure 2-1 Inserting the adapter in an expansion slot