Installation guide

Booting up the PC from a Server 3-3
5 Install the EtherPaC 2000+ Adapter in the PC and turn on
the PC.
6 To enable the PC’s remote boot function:
Start the Setup program. (See "Starting the Setup program"
on page 2-7)
In the Set Configuration Menu, select the appropriate
address from the Boot ROM base address options.
Press <F3> to save the configuration.
Figure 3-2 The Set Configuration Menu
7 The system restarts after you save the configuration.
The card configuration is as follows:
LAN Adapter Setup Program
Version 2.01 Releas e Date: June 11, 1993
SET CONFIGURATION MENU
Adapter Mode
Base I/O Address
IRQ Interrupt
Transceiver
Press any key to continue.
LAN Type: Ethernet Slot: 16-BIT
Network Address: 00 00 E6 C0 FD 7D
Boot ROM Base Address
Turbo Mode
: NE2000
: 0300
: 3
: T.P.
: D8000
: DISABLE