Installation guide

3-2 Booting up the PC from a Server
Installing the EtherPaC Boot ROM
You install the Boot ROM in the ROM socket of the Asanté EtherPaC
Adapter.
1 If the EtherPaC 2000+ is installed in the PC and connected
to the network, turn off the PC and disconnect and remove
the adapter.
❖ Note: Follow the safety instructions described on
page 2-2.
2 Take the Boot ROM out of its protective packaging.
3 Check all pins on the ROM to make sure none are bent.
4 Locate the socket for the Boot ROM on the adapter.
Align the Boot ROM’s notch and pins with the socket’s
notch and pins and gently press the ROM into the socket.
See Figure 3-1.
Be careful not to bend the pins.
Figure 3-1
The Boot ROM socket on the adapter
Boot ROM
notch
socket