Installation guide

2-12 Installing and Conﬁguring the Adapter

Testing the EtherPaC 2000+ Adapter

The Setup program provides a diagnostic program for testing the Ether-

PaC 2000+ Adapter. The best way to run the test is to run it simulta-

neously on two or more PCs on the network. You can run the test on

a single PC.

To test one or more adapters:

Select

Test the Adapter

in the Main Menu of Setup.

The program runs a number of tests and indicates the

results with PASS or FAIL in the Test the Adapter Menu.

When a test fails, an error is reported and suggested action

for solving the problem is given.

Figure 2-8

The Set Conﬁguration Menu

Use or to select one of the following.

LAN Adapter Setup Program

Version 2.01 Release Date: June 11, 1993

TEST THE ADAPTER MENU

Then press Enter.

Configuration Test

I/O Test

ID Test

RAM Test

Press <F1> to Reset Counter. <F2> to Toggle ON/OFF, <ESC> to Exit

LAN Type: Ethernet Slot: 16-BIT

Network Address: 00 00 E6 C0 FD 7D

Internal Loopback Test

External Loopback Test

: PASS

Interrupt Test

Network Function Test

: PASS

Tx Count

Time

: 0 Packets

: 0 Seconds

Node ID: [00 00 E8 C0 FD 8D]

ch 2 Page 12 Monday, August 26, 1996 11:06 AM