Installation guide

2-10 Installing and Configuring the Adapter
Configuring individual parameters on the adapter
1 Select
Set Configuration
from the Main Menu and press
<Enter> .
The Set Configuration Menu appears with the Adapter Mode
value highlighted.
2 To change a parameter value, first select it by using the
UP
or
DOWN
arrow key, then press
<Enter>.
A pop-up menu appears showing the available values for the
selected parameter.
The example in Figure 2-7 shows the options available for
the Base I/O address.
Figure 2-7 The Set Configuration Menu
Use or to select one of the following.
LAN Adapter Setup Program
Version 2.01 Release Date: June 11, 1993
SET CONFIGURATION MENU
Then press Enter.
Adapter Mode
Base I/O Address
IRQ Interrupt
Transceiver
Enter = Select ESC = Cancel F1 = Help F3 = Save
LAN Type: Ethernet Slot: 16-BIT
Network Address: 00 00 E6 C0 FD 7D
Boot ROM Base Address
Turbo Mode
: NE2000
: 0300
: 3
: T.P.
: D8000
: DISABLE
0240
0280
0300
02C0
0320
0340
0360
ch 2 Page 10 Monday, August 26, 1996 11:06 AM