Installation guide

Installing and Configuring the Adapter 2-9
Figure 2-6
The default values in the card configuration
The supported settings for each parameter are listed in
Appendix A.
The board parameters and their default value are
Adapter Mode
—Selects NE2000.
I/O Base Address
—7 addresses are available ranging from
0240 to 0360; 300H is the default setting. IRQ Interrupt—8
values are available values for a unique IRQ channel.
Transceiver
—configures the unit to the correct cable type.
The default setting depends on your adapter type.
Boot ROM Base Address
—8 options are available ranging
from C0000H to DFFFFH, excluding the Disable selection.
The default is Disable.
Turbo Mode
—set to Enabled only if the adapter fails when
the NE2000 mode is used due to incompatibility between
the PC’s AT-bus and the adapter’s I/O Channel Ready signal
(I/O CHRDY). The default is Disabled.
The card configuration is as follows:
LAN Adapter Setup Program
Version 2.01 Release Date: June 11, 1993
SET CONFIGURATION MENU
Adapter Mode
Base I/O Address
IRQ Interrupt
Transceiver
Press any key to continue.
LAN Type: Ethernet Slot: 16-BIT
Network Address: 00 00 E6 C0 FD 7D
Boot ROM Base Address
Turbo Mode
: NE2000
: 0300
: 3
: T.P.
: D8000
: DISABLE
ch 2 Page 9 Monday, August 26, 1996 11:06 AM