Installation guide

Installing and Configuring the Adapter 2-7
Starting the Setup program
If you’re going to run the Setup program from the hard disk, create a
new DIAG directory on drive C. You can also run Setup from the floppy.
1 Insert the ETHERPAC UTILITY AND DRIVERS disk in drive A
or B.
Go to the DIAG directory.
2 After the DIAG> prompt, enter:
setup <Enter>
The Board Selection Menu appears. Each board in the PC is
identified in the window (maximum—3).
Figure 2-4 The Board Selection Menu
If the same I/O base address is used on two cards, you have
a conflict and must change the I/O base address on one
card.
LAN Adapter Setup Program
Version 2.01 Release Date: June 11, 1993
BOARD SELECTION MENU
Use or to select a board to be diagnosed.
Then press Enter.
Board Type: 16: BIT ISA ADAPTER I/O Base: 0300
Enter = Select ESC = Cancel F1 = Help
If only one board appears above and two or more
are in the PC, then the I/O base addresses on two
boards are the same, resulting in a conflict.
Board Type: 16: BIT ISA ADAPTER I/O Base: 0280
ch 2 Page 7 Monday, August 26, 1996 11:06 AM