Installation guide

2-4 Installing and Configuring the Adapter
4 Gently press the card into the expansion slot until it is fully
seated.
Fasten the holding screw to ground the card to the chassis.
See Figure 2-3.
Figure 2-3
Inserting the adapter in an expansion slot
5 Replace the computer’s cover.
6 Connect the Ethernet cable to the adapter.
Make sure the PC is turned off and the cable’s metal con-
nectors do not touch any metal objects in the computer.
Follow the guidelines given below for your cable type:
With a 10BaseT cabling
Plug the cable’s RJ45 connector into the RJ45 jack on the
adapter and plug the other cable end into a 10BaseT net-
work hub. Be sure the cable between your computer and
the hub is not longer than 328 feet or 100 meters.
ch 2 Page 4 Monday, August 26, 1996 11:06 AM