Installation guide

Installing and Configuring the Adapter 2-3
Installing an EtherPaC 2000+ Adapter
To install an EtherPaC 2000+ adapter:
1 Turn off the computer and disconnect and remove the
power cable.
2 Remove the computer cover.
Figure 2-1
Removing the cover
3 Insert the card into an empty 8-bit or 16-bit expansion slot.
For faster performance, use the 16-bit slot.
You do not need to set any jumpers or switches on the
adapter.
∆
Important : With the
3-in-1 EtherPaC 2000+ Adapter
,
if you’re using Thick Ethernet cable, set the JP5 trans-
ceiver jumper to AUI. The default is BNC.
Figure 2-2
Setting JP5 jumper for AUI on 3-in-1 Adapter
screws for
mounting cover
N
C
BNC
AUI
JP5
ch 2 Page 3 Monday, August 26, 1996 11:06 AM