Product specifications

91
6. Press the board Þrmly until the connector is seated.
Do not force the board. If you meet with a lot of resistance, pull it
out, inspect the connector pins, and try again.
7. Install the board hold-down rail.
8. Replace the broadcast panel if you removed it.
a. Reconnect any cables that you disconnected. For details see
Table 5-3.
b. Carefully place the excess cables into the broadcast panel,
making sure they do not bind.
c. Hook the mounting tabs in their slots in the rear panel.
d. Tighten the thumbscrews.
n
Some broadcast panels do not use all of the cables listed in Table 5-3.
Table 5-3 Broadcast Panel Cable Connections
Cable Connection
Analog video cable Connects to the bottom connector on the ABVB with analog
I/F board. (Leave disconnected when using the digital I/F board.)
Digital video cable Connects to the bottom connector on the ABVB with
digital I/F board. (Leave disconnected when using the
analog I/F board.)
UI monitor cable Connects to the top connector on the ABVB.
Remote ADB cable Connects to the ADB port below the panel.
SIO cable 1 (Printer) Connects to the Apple printer port below the panel.
SIO cable 2 (Modem) Connects to the Apple modem port below the panel.
SIO cable 3 Connects to the top connector of the serial expander board.