Specifications

B - 8 WFPEEUI220001C0
ECCP Software Installation
Re-Installing/Upgrading the ECCP Software (Windows NT)
The following procedures are used to re-install or upgrade the
ECCP-related software on a node running Windows NT 4.0.
1. Load the CD-ROM disk containing the Conductor NT soft-
ware into the CD-ROM drive.
2. Select Start > Settings > Control Panel.
3. In the control panel window, double click Network. The net-
work window will be displayed.
4. In the network window, select the Adapters tab. In the list
of network adapters, select ABB Automation PCI Ethernet
Adapter.
5. Click Update to display the Windows NT setup.
6. In the text box in the Windows NT setup window, enter the
CD-ROM drive specification, followed by the directory
i386\ECCP\NT4
i386\ECCP\NT4i386\ECCP\NT4
i386\ECCP\NT4. For example, if the CD-ROM is drive D:,
enter the following:
D:\i386\ECCP\NT4
7. Click Continue in the Windows NT setup window. The nec-
essary files will be copied onto the hard drive of the Conductor
NT console.
8. In the network window, select the Services tab. In the list of
network services, select ECCP Utility Driver.
9. Click Update to display the Windows NT setup window.
10. In the text entry box in the Windows NT setup window,
enter the CD-ROM drive specification, followed by the directory
designation i386\ECCPUTIL
i386\ECCPUTILi386\ECCPUTIL
i386\ECCPUTIL. For example, if the CD-ROM is
drive D:, enter:
D:\i386\ECCPUTIL\NT4
11. Click Continue in the Windows NT setup window. The nec-
essary files will be copied onto the hard drive of the Conductor
NT console.
12. Click OK to exit the network window.