Specifications

ECCP Software Installation
WFPEEUI220001C0 B - 7
7. Click OK. The OEM option window will be displayed.
8. Select the following item from the list in the OEM window:
ABB Automation PCI Redundant Ethernet Adapter
9. Click OK.
10. Allow the installation to complete.
11. In the network window, select the Protocols tab, then click
Add. The select network protocol window will be displayed.
12. In the select network protocol window, click Have Disk.
13. Insert the manufacturer’s disk and enter the CD-ROM
drive specification, followed by the directory i386\ECCPUTIL
i386\ECCPUTILi386\ECCPUTIL
i386\ECCPUTIL.
For example, if the CD-ROM is drive D:, enter:
D:\i386\ECCPUTIL\NT4
14. Click OK. The select OEM option window will be displayed.
15. Select the following item:
ABB Utility Driver v3.5
16. Click OK to complete the selection operation.
17. Allow the installation to complete.
18. Click OK or CLOSE in the network window. The TCP/IP
configuration window will be displayed.
19. Configure the appropriate information (e.g., the IP address
and the subnet mask (255.0.0.0)). Refer to Connecting to a
Connecting to a Connecting to a
Connecting to a
Control Network (Cnet)
Control Network (Cnet)Control Network (Cnet)
Control Network (Cnet), Cnet Addresses
Cnet Addresses Cnet Addresses
Cnet Addresses and Appendix D.
Click OK.
20. A pop-up window will provide the opportunity to restart the
computer. The computer must be restarted for the newly
installed software to take effect.
21. Verify the operation of the physical Ethernet interface and
TCP/IP protocol. Use the ping utility (from an MS-DOS com-
mand window) to verify that the Conductor NT console can be
accessed on the network. (The ping utility is a standard Win-
dows utility. Refer to the Windows documentation for details
on the use of ping.)