Specifications

ECCP Board Installation
WFPEEUI220001C0 B - 5
7. Make sure that no components on the motherboard (e.g.,
heat sinks) interfere with the ECCP board when it is fully
inserted in the motherboard card slot.
8. Replace the cover of the computer.
9. Attach the AAUI transceivers to the AAUI-compatible ports
on the ECCP board.
10. Attach the Cnet cables to the AAUI transceivers.
11. Reconnect all devices and cables.
12. Turn the computer on.
Testing the correctness of the ECCP board installation can be
performed after the ECCP driver and related software are
installed. Refer to ECCP Software Installation
ECCP Software InstallationECCP Software Installation
ECCP Software Installation. The dualutil
diagnostic utility for the ECCP board is discussed in ECCP
ECCP ECCP
ECCP
Board Diagnostics - the DUALUTIL Utility
Board Diagnostics - the DUALUTIL UtilityBoard Diagnostics - the DUALUTIL Utility
Board Diagnostics - the DUALUTIL Utility.
Single and Dual Interface Coexistence - Considerations
It is possible to install both a third-party, single channel Ether-
net communications interface board and an ECCP dual Ether-
net communications interface board on the same Conductor
NT console. When this is the case, DCUs should be connected
DCUs should be connected DCUs should be connected
DCUs should be connected
only to the Cnet attached to the ECCP board
only to the Cnet attached to the ECCP boardonly to the Cnet attached to the ECCP board
only to the Cnet attached to the ECCP board. No DCUs
should be present on an Onet attached to the single channel
Ethernet communications interface board. The presence of
DCUs on both networks can lead to unpredictable and unde-
sirable results.
Installation of both ECCP and single channel Ethernet boards
is useful when printers and printer servers must be installed.
Printers and printer servers should not be attached to the
redundant Cnet; typically, they are installed on the Onet. If a
Cnet network is in use, but no Onet is available, then a single
channel Ethernet board in the Conductor NT console can be
used to connect to a separate network containing printers and
printer servers. Refer to Connecting to a Control Network
Connecting to a Control Network Connecting to a Control Network
Connecting to a Control Network
(Cnet)
(Cnet)(Cnet)
(Cnet) and Appendix D for more information about supported
network configurations.