Specifications

B - 4 WFPEEUI220001C0
ECCP Board Installation
Inserting the ECCP Board
This section details the steps needed to insert the ECCP board
in the expansion slot of the personal computer on which the
Conductor NT software will be installed.
NOTE: The internal configuration of personal computers can vary between
models and between manufacturers. If there are questions about the internal
layout of the PC, or difficulty in following the steps below, refer to the documen-
tation that came with the computer.
1. Prepare to install the ECCP board as follows.
a. Turn off the computer and unplug the unit from its
power source.
b. Disconnect all cables that are connected to the main
system unit.
c. Remove any jewelry from hands and wrists.
d. Use only insulated or nonconductive tools.
2. Remove the cover of the computer.
3. Choose an expansion slot. This can be any PCI slot that
can accommodate a full length PCI board.
4. Remove the backplate of the expansion slot by removing
the screw found at the top of the backplate. Retain this screw
for use in a later step.
5. Install the ECCP board into the expansion slot. Do not
touch the gold fingers on the connector edge when handling
the ECCP board. Make sure that the board is firmly seated in
the connector slot.
6. Secure the ECCP board to the computer chassis, using the
screw retained in step 4. The attachment is made at the top of
the expansion slot.
WARNING
The ECCP board will be installed in a computer which operates
with voltages that can be lethal. Before you remove the com-
puter cover, observe the following precautions in Step 1 to pro-
tect yourself and prevent damage to the systems components.