Specifications

ECCP Software Installation
WFPEEUI220001C0 B - 11
36. Allow the installation to complete.
37. Click CLOSE in the local area connection properties
window.
38. Configure the appropriate information (e.g., the IP address
and the subnet mask (255.0.0.0)). Refer to Appendix D. Click
OK.
39. Verify the operation of the physical Ethernet interface and
TCP/IP protocol. Use the ping utility (from an MS-DOS com-
mand window) to verify that the Conductor NT console can be
accessed on the network. (The ping utility is a standard Win-
dows utility. Refer to the Windows documentation for details
on the use of ping.)
Re-Installing/Upgrading the ECCP Software (Windows 2000)
The following procedures are used to re-install or upgrade the
ECCP-related software on a node running Windows 2000.
1. Load the CD-ROM disk containing the Conductor NT soft-
ware into the CD-ROM drive.
2. Select Start > Settings > Network And Dial Up Connections.
3. In the network and dial up connections window, right-click
the name of the connection whose device name is ABB ECCP
dual redundant PCI redundant ethernet adapter.
4. Select Properties from the pop-up menu.
5. Click Configure on the general tab.
6. Click Update on the driver tab to start the upgrade
procedure.
7. Enable Display a list of the known drivers for this device.
8. Select Network Adapter from the list of drivers.
9. Click Yes in the digital signature not found dialog box.
10. Click Finish to complete the installation.
11. In the network and dial up connections window, right-click
the name of the connection whose device name is ABB ECCP
dual redundant PCI redundant ethernet adapter.